Bring your radio back to life with this stock replacement 4‑pin CB microphone. Pre‑wired to the widely used Cobra/Uniden standard, it’s a simple, plug‑and‑talk solution for most 4‑pin CB and 10‑meter radios from Cobra, Uniden, Galaxy, Connex, General, Stryker, Ranger, Superstar, and others. The dynamic mic element delivers clear, natural voice quality without distortion, while the rugged PTT switch and reinforced strain relief stand up to daily use in the truck or the shop. No batteries or extra power needed—just connect, key up, and go.

Compatibility

• Works with most 4‑pin radios using Cobra/Uniden wiring, including many models from: Cobra, Uniden, Galaxy, Connex, General, Stryker, Ranger (RCI), Superstar, President (select 4‑pin models), and similar

• Not for 5‑pin/6‑pin or RJ‑style mics; not for radios that use non‑standard 4‑pin wiring without rewiring

Technical Specs

• Connector: 4‑pin round (standard mic jack), metal locking collar

• Wiring standard: Cobra/Uniden (most Galaxy/Connex/General/Stryker/Ranger/Superstar follow this)

• Element: Dynamic (no external power required)

• Impedance: ~500–600 Ω (typical)

• PTT: Momentary switch to ground (TX), dedicated RX line

• Cord: Coiled, approx. 3 ft relaxed, 6–9 ft extended

• Housing: Impact‑resistant ABS with reinforced strain relief

• Included: Microphone with 4‑pin plug, hang‑up clip, mounting screws

Standard 4‑Pin Cobra/Uniden Pinout

• Pin 1: Mic Audio

• Pin 2: Ground/Shield

• Pin 3: Transmit (PTT)

• Pin 4: Receive

Installation

• Power off the radio

• Align the 4‑pin plug and seat fully

• Hand‑tighten the locking collar

• Power on and perform a quick radio check

Notes and Tips

• A few radios use different 4‑pin wiring. If your radio doesn’t key up or audio is missing, verify the pinout in your manual.

• Some Midland, President (older), and specialty/export models may require rewiring to match the Cobra/Uniden standard.

• For best results, keep the mic 1–2 inches from your mouth and speak across the mic at a slight angle.